Repair/Rebuild Flippers

-Replace Coil sleeves

Clean or replace EOS switches

Replace Coil Stop

Replace Flipper Linkage

Replace Flipper Bushing

Replace Flipper Buttons

Replace coil sleeves in slingshots

Replace coil sleeves in poppers

Inspect Metal Shaft, yoke, and stopper -

Check Spoon to make sure there is no hole

Clean and adjust old metal light sockets; make sure they don't flicker

Inspect Popper Skirt

Test all Lights in Backglass & add FX

Replace Lights in Door & Start/extra ball button

When finished, turn on all lamps+ flashers, test, and make sure all your bulbs are working

Check all global illumination circuits on Playfield & Backglass

Replace all playfield rubbers

Install New Flipper Rubbers

Install New Plunger rubber

Clean & Adjust Popper switches; replace broken Skirts if needed. Install new sockets if needed

Sonic Clean or replace plastic posts

Clean Playfield

Clean & Adjust Slingshots

Level Pinball, and set at correct slope angle 5.5-6.0 for older games, 6.5 for newer

Install New Balls

Clean Plastics

Restore Pinball "Free Play" Card in Apron

Adjust Slingshot Sensitivity; also, clean separate point switch

Test Drop Targets & level

Make sure all Check Global Illumination sections are working

Replace missing foam behind stand-up targets

Remove & Clean Subways

Clean Inserts if LEDs are installed

Dremel all older leaf switches

Vacuum inside a cabinet & coin Drawer (while playfield is up)

Set to Freeplay

Set # of Balls per play to match info card

Set Replay Scores to match info Card

Set Reply to award extra ball (not credit)

Make sure settings reflect what is described in info card

Check drop targets to make sure they are flush with playfield

Check grounding strap connecting head to cabinet

Check for rust on external bolts

Look for rust on coin door

Make sure coin door and head have a lock, and they work correctly; spray silicone in old locks

Look for stickers or residue and remove

Restoration Pinball Sticker on coin tray or inside door

Check topper lights (if present)

check/replace backglass lifter

Put all paperwork in Restoration Pinball Manilla envelope

Clean backglass.

Check feet levelers; replace if bad

Buff off Rust on metal backglass lifters

Clean the underside of the lockdown bar. And add a new seal.

Check power plug to make sure that ground is present; if not repair 

Plunger lube & New Spring

Clean Score Reels Faces

Clean & Adjust All Score Motors & Rebuild if necessary

Test all chimes & check rubber grommets

Clean & Adjust all Relays

Clean & Adjust All Step Motors & Rebuild if necessary

Replace all Pop bumper Skirts

Playtest for 20 minutes

Make sure the ball passes through all sections of the pinball machine

Make sure the ball does not get stuck on older inserts

Make sure all flippers are strong enough to make ramps

At the end of 20 minutes, make sure no errors are displayed on startup

Do a final QUick clean and wax

Clean both sides of playfield glass

Demonstrate that all lights work

Check Slope

Check level

Review work completed with Customer

Collect final payment

Terms

A 30-day warranty is included in all work listed above. On-site service includes travel up to 25 miles. Additional mileage will incur extra cost or necessitate a video conference call. Incandesent Light bulbs are not covered.